Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

To load non-ABAP Transports into TM in a predefined project/ destination and status, a special loader can be used.

Scenario:

You want to load non-ABAP Transports into TM in a predefined project/ destination and status.

For example, you have a PO system which is connected to a SAP solution manager Solution Manager (referred as ABAP communication system) via CTS+ and if the transports are released in the PO system, you want them to be added into TM automatically.

Configuration steps

  1. Connect your ABAP communication system to TM (see manual: non-ABAP systems).

  2. Connect your none-ABAP Systems to TM (see manual: non-ABAP systems).

  3. Maintain table /RTC/TM_TAUT in the ABAP communication system:

    1. R3 SID: SID of your development system (where the transport request originates from). E.g., if you want to load PO transports, the SID might be POD or similar. You can check this in your ABAP communication system, checking the transport request prefix.

    2. R3 CLIENT: The client your transports are associated with. If you are not sure, you can check the client information in table E070C.

    3. D TM: The SID of your TM System.

    4. PJ DESTINAME: The TM project, you want the transport request to be added. Please use the exact name (no typos, case-sensitive), otherwise the loader will not work.

    5. DESTI NAME: The TM destination you want the transport request to be added. Please use the exact name (no typos, case-sensitive), otherwise the loader will not work.

    6. Status: The initial status of the transport request. (The initial level is configured in determined by the TM destination).

  4. Schedule report /RTC/TM_LD_81 081 periodically on the ABAP communication system. Any time it runs, it checks for new released transport requests from your non-ABAP system and will insert them into TM.

...

Once the transport request have been loaded into TM, they will be written into table /RTC/TM_LOAD. If you want to reload them, you have to delete the respective entries in this table.

...